AMPZILLA 2000 2nd EDITION SPECIFICATIONS
- POWER OUTPUT
16 Ohms - minimum 150 watts 20Hz to 20kHz
8 Ohms - minimum 300 watts 20Hz to 20kHz
4 Ohms - minimum 500 watts 20Hz to 20kHz
- Total T.H.D. & I.M. Distortion
4 to 16 Ohms less than .05% at any power level
up to rated
at any frequency or combination of
frequencies between 20Hz and 20kHz.
- Input Impedance and Sensitivity
1 volt R.M.S. across 50kohms for 300 watts into
8 ohms on the unbalanced input.
(note: the impedance value can be adjusted to
any value up to 1 megohm-consult the factory)
+/- 1 volt R.M.S. across +/- 70kohms for 300 watts
into 8 ohms on the balanced input.
Input selector switch for balanced or unbalanced
- Frequency response and power bandwidth at rated power
8 ohms - better than +/- .2 dB 20Hz to 20kHz
4 ohms - better than +/- .3 dB 20Hz to 20kHz
- Stability
100 % stable into any load angle 0 to 90 degrees,
capacitive or inductive, regardless of waveshape
- Damping factor
Greater than 250 at 20Hz
- Noise
Better than -120dB relative to full rated power
Protection Power switch/circuit breaker 4 DC
power supply fuses with indicators
Gold plated input and dual output jacks
All steel 14 ga. Chassis, powder coat finish Peak clipping
indicator LED, thermal LED
The entire amplifier circuitry (except the power output stages)
is contained on one main drive card which also contains the input
jacks. This means that the amplifier is completely upgradeable
with future circuit improvements.
jamesbongiorno@ampzilla2000.com
